6 channel DMX Controller Driver | LED Tape etc.
DMX Mini 2 – LED Driver, 6channels.
A small, DMX controlled, 6 channel LED driver board for common anode voltage-driven LEDs. Option to have embedded firmware with custom DMX programmes. Drives: 2.5A per channel, 15Amps total. For voltage driven, constant voltage leds only.
Order, explore our discounts or
get expert DMX hardware advice today:
SKU: MLE-DMXMINI2.
DMX Mini 2 Features:
USITT DMX512 / 1990 (4µSec) compliant
High current fused outputs
Fully selectable DMX base address
On-board terminate setting (120 Ohm)
Full isolation from DMX connection for maximum reliability
Power and Data indicator LEDs
Built in stand-alone programs
Protection against reverse power input
Custom builds available
DMX Mini Specifications:
Size: 43 x 110.5 mm (PCB), 14mm max. above PCB and 3mm below.
Fixings: 4x 3.25mm holes on 102.87 x 35.56mm centres.
Weight: 43g approx.
Power connection: 2x Screw terminals, 5mm pitch.
Input voltage: 12 or 24Vdc, specified when ordering.
Quiescent current: 30mA at 12Vdc (no DMX signal).
DMX connection: 3x Screw terminals, 3.81mm pitch.
DMX input: RS-485 compliant.
Output connection: 12x Screw terminals, 5mm pitch.
Output current: 2.5A maximum (fused) per channel.
Output voltage: Same as input voltage.
PWM Frequency: 100Hz approx.
DMX Settings
DIP Switch Settings:
1= DMX base address (1) 6= DMX base address (32)
2= DMX base address (2) 7= DMX base address (64)
3= DMX base address (4) 8= DMX base address (128)
4= DMX base address (8) 9= DMX base address (256)
5= DMX base address (16) 10= Terminate (on/off)
DMX Addressing (Firmware version 1.1):
Address 0 – Sleep mode (device can safely remain on DMX bus) Address 1 to 508 – Normal DMX function
Address 509 – Steps through each output channel sequentially Address 510 – Cross fade pattern, R-G-B-R-G-B-R….
Address 511 – All channels on full (lamp test)